Resolving Replacment UPVC Door Handles Issues

UPVC door handles will often stop working and there are a variety of reasons as to why, but this problem can often be very frustrating and sometimes expensive to fix. However, if you are attempting to fix it yourself then we have put together a mini guide to help you out.

One of the main causes for why replacement door handles are needed is due to general wear and tear. Like most things these handles won't last forever and excessive use can shorten the handles durability, as they can often become difficult to turn and unlatch. As well as this, there can be problems with the lock in uPVC doors, and the deadbolt can become stuck, making it difficult to open the door.

Such problems can be caused by a range of things, including the following:
•    Screws that are too tight can result in the handle’s backplate pinching the lock, thereby preventing the spring from working effectively

•    The handle’s internal springs may bind against the inside of the handle backplate if they’re not properly lubricated

•    Sometimes, the handle is prevented from operating properly if there is insufficient clearance behind the handle’s backplate, stopping it from turning freely

•    The spring mechanism can fail within the lock or lever handle

There are a number of ways to resolve such problems, including removing and cleaning the door handle itself, but this isn’t always necessary.  Instead, why not try some of the following tips to get your door handle working again:

•    Try slightly loosening the screws that hold the handle to the door itself.  This should make the handle easier to turn.

•    Remove the handle from the door and operate it while holding the backplate.  If the handle does not operate freely, try adding a little grease to it and allowing it to work into the mechanism.  This should stop the mechanism from binding, and the handle can be fitted to the door again.

•    If the door isn’t latching shut properly, it’s likely that the spring mechanism within the lock has failed.  To test if this is the case, remove the latch from the door and try pressing it with your finger; if it doesn’t spring back fully or is very slow when doing so, you’ll need to replace it.

There are number of tips available when it comes to repairing or replacing door handles, and should you find that you need to replace specific parts – or the handle itself – on internal doors or uPVC doors, Doorfit have a huge range of door fittings, locks and mechanisms from all the major manufacturers, including Avocat and ERA, among others.



Our dedicated team will be more than happy to give you advice about the best way to repair or replace your door handle, and will be delighted to show you the most suitable products for your particular needs. So why not take a look today to see how Doorfit can help you.